How to maximize the service life of mobile lighting monitoring trailers

How to maximize the service life of mobile lighting monitoring trailers

Introduction
Mobile lighting monitoring trailers are an important equipment widely used in night construction, engineering repair, disaster rescue, fire lighting and other scenes. Due to its high frequency of use in complex environments, the service life of the equipment is often affected by many factors. In order to ensure the long-term stable operation of the equipment and extend its service life, this article will provide detailed guidance on daily maintenance, regular maintenance, environmental adaptability, troubleshooting and repair.

1. Daily maintenance
Cleaning and inspection
Before each use, clean the surface of the lamp to ensure that there is no dust, dirt or other foreign matter attached.
Check the oil level to ensure that the oil is sufficient and there is no leakage.
Air filter maintenance
Check the air filter every time it is used, and clean it every 3 months or after 50 hours of use. If the equipment is used in a dusty environment, it is recommended to clean it once a month.
Fuel filter maintenance
Clean the fuel filter every 6 months, check whether the filter is clogged, and replace it if necessary.
Spark plug maintenance
Clean the spark plug every 6 months, clean the carbon deposits and check the gap. Replace the spark plug once a year.
Lifting rod maintenance
Clean the lifting rod every 6 months to ensure that it is well lubricated. If the device is used in a dusty environment, it is recommended to clean it once a month.

2. Regular maintenance
Oil change
Replace the oil 1 month or 250 hours after the first use, and then every 6 months. When changing the oil, make sure the device is in a hot state so that the old oil can be completely discharged.
Lamp replacement
When replacing the lamp, wait for the lamp to cool naturally before operating to avoid burns. Use gloves to replace the lamp to prevent fingerprints from affecting the service life of the lamp.
Circuit inspection
Regularly check the circuit connection wires and plugs to ensure that there is no poor contact or short circuit. Keep the circuit dry to avoid short circuits caused by moisture.

3. Environmental adaptability
Temperature control
Avoid running the device for a long time in high temperature (over 35°C) or low temperature (below 0°C). High temperature will accelerate battery aging, and low temperature may make it difficult to start the device.
Moisture and dustproof
When storing the device, ensure that the environment is dry and regularly check the moisture and dustproof conditions of the device.
Thunderstorm protection
When used in thunderstorms, ensure that the equipment is reliably grounded to avoid lightning strikes. The distance between the lamp panel and the high-voltage line after it is raised should be at least 5 meters.

4. Troubleshooting and maintenance
Engine failure
If the engine cannot start, check whether the fuel is sufficient, whether the engine oil is sufficient, and whether the spark plug is working properly.
Lifting rod failure
If the lifting rod cannot be raised and lowered normally, check whether the air pump switch is turned on and whether the air supply pipe is well connected.
Circuit failure
If there is no voltage output, check whether the circuit connection is good, and contact professional maintenance personnel if necessary.

5. Extend battery life
Charging management
Avoid the battery being in a full or low power state for a long time. It is recommended to keep the battery power between 25% and 75% to reduce cycle loss.
Temperature management
Avoid charging in a high temperature environment and ensure that the charging environment temperature is between 0℃ and 35℃.
Storage conditions
When storing for a long time, keep the battery power at about 50% and place it in a cool and dry place. Perform a charge and discharge cycle every 6 months.

6. Summary and Outlook
Through scientific daily maintenance, regular maintenance, environmental adaptability management and troubleshooting, the service life of the mobile lighting monitoring trailer can be significantly extended. In the future, with the advancement of technology, the intelligence and automation level of the equipment will be further improved, providing users with reliability and durability in actual use.